®
Operation
Place Bracket Bolts (G) with a 5/16 inch washer (I)
through the Outer Headboard Bracket (E) and into
the Inner Headboard Bracket (D). Use 5/16 inch
washers (I) and 5/16 inch nuts (J) and hand tighten to
allow for adjustment.
Repeat on the other side.
STEP 1D
Ensure the Headboard Bracket is assembled with a
distance of 1.5 (38.1 mm) to 2 inches (50.8 mm)
between the edge of the Ergo System and the
headboard bracket assemblies.
STEP 2
Attach your headboard to the Headboard Brackets
following the steps below:
STEP 2A
Measure the center-to-center distance of the
mounting holes in your headboard.
STEP 2B
Measure the center-to-center distance of the
mounting holes in the Headboard Bracket Assemblies.
STEP 2C
If the Headboard Brackets require adjustment, loosen
the bolts that are holding the Outer Headboard
Brackets and move them so that the mounting holes
on the Outer Headboard Bracket align with the
mounting holes on your headboard. Reinstall the
bolts on the Outer Headboard Bracket and firmly
tighten.
STEP 2D
Place your headboard bolts through the mounting
holes on both the Outer Headboard Bracket and your
headboard. Firmly tighten.
STEP 3
Place your Tempur-Pedic mattress on top of your Ergo
System Base.
WARNING: Verify the space between the
headboard cross member and the top of the
mattress is no more than 3 inches.
Your TEMPUR
®
Advanced Ergo System
™
installation is now
complete. Refer to the Wireless Remote Control Guide
on the following pages or the supplied Quick Reference
Guide for additional usage instructions.
Wireless Remote Control Programming
ONE WIRELESS REMOTE CONTROL AND ONE ERGO SYSTEM
NOTE: Only replacement wireless remote
controls require user programming. You can
program up to two remotes per base.
STEP 1
Place four AAA batteries into the Wireless Remote
Control.
STEP 2
Ensure the Ergo System base is plugged into a
functioning outlet.
STEP 3
Locate the Emergency Power Down Box under the
Ergo System base and install two (2) new 9-volt
batteries.
STEP 4
Lightly press the learn button for three (3) seconds.
STEP 5
When the Green LED light illuminates, the RF
frequency code setting function will be activated.
Note: The LED light is located on the side of the
plastic housing and is only visible when lit. If a new
signal is not received, it will reset itself to normal
mode in 10 seconds.
STEP 6
Press any button on the wireless remote control. The
Green LED light will blink once it receives a remote
signal. Note: the bed will not respond for 10 seconds
during the remote learn process.
STEP 7
When the Green LED light on the Emergency Power
Down Box turns off, you have completed the learning
process of the RF frequency code.
NOTE: The remote programming procedure
may also be performed using the learn
button on the PLC.
ONE WIRELESS REMOTE CONTROL AND TWO ERGO SYSTEMS
STEP 1
On your first Ergo System, follow the directions for one
(1) wireless remote control and one (1) Ergo System.
STEP 2
Once you have completed the programming of your first
Ergo System, repeat the same directions for the second
Ergo System using the same wireless remote control.
14
Customer Service: 1–800–979–1457
15
Customer Service: 1–800–979–1457
