A.
B.*
E.
H.*
K.
C.
F.*
I.
L.
D.
G.
J.
M.
®
Installation
Before discarding any packing materials, check your
TEMPUR
®
Advanced Ergo System
™
carton and verify the
following items in the parts list are included:
PARTS LIST
A. Wireless Remote Control (1) and
Four (4) AAA Batteries
B. Mattress Retainer Bar (1)*
C. Bed Leg with Caster (6)
D. Inner Headboard Bracket (2)
E. Outer Headboard Bracket (2)
F. Retainer Bar Bolt (4)*
G. Bracket Bolt (6)
H. Retainer Bar Plate (2)*
I. 5/16 Inch Washer (12)
J. 5/16 Inch Locking Nut (6)
K. Allen Wrench (1)
L. Wrench (1)
M. 9-Volt Batteries (2)
*Attached to base for shipping
Installation Instructions
STEP 1
Carefully lift your Ergo System out of the shipping
carton, keeping the unit top side down. For safety
reasons, this should be performed by 2 people.
STEP 2
Attach Ergo System Legs:
Open the accessories box, take out the 6 legs, and
thread them in a clockwise direction into the
pre-threaded holes in the frame.
NOTE: Hand tighten the legs securely to the
frame. Do NOT over tighten. Make sure the legs
are screwed completely into the frame. Legs that
are not securely attached may become unsafe.
DO NOT unscrew a leg to compensate for an
uneven floor.
NOTE: Your Ergo System is equipped with
special locking casters. In order to prevent the
movement of this product, all six casters should
be in the locked position. You are strongly
encouraged to place rubber caster cups or
carpet squares (not provided)
under the casters in addition
to locking them in place.
Although the casters lock and
will not roll, they may slide.
STEP 3
Remove and extend the power cord from the frame.
WARNING! POWER CORDS MUST NOT INTERFERE
WITH ANY ERGO SYSTEM MECHANISMS.
STEP 4
Remove and extend Power Down Box from frame.
Install 9-Volt Batteries.
STEP 5
Carefully flip the Ergo System over to the “topside
up” position and remove the plastic packaging from
the product.
10
Customer Service: 1–800–979–1457
11
Customer Service: 1–800–979–1457
