Tempsens CALsys 1500 BB, Руководство пользователя

Страница: 11 / 17

will switch the CALsys 1500BB ON or OFF to raise or lower the temperature. The
displayed temperature will gradually change until it reaches the setpoint temperature.
The temperature bath requires 15 to 20 minutes to reach the set-point depending on the
span. Another 10 to 15 minutes is required to stabilize the temperature bath within ±
1.0ºC of the set-point.
5.3 Operating Instruction:-
1.
after the completly installation.
2. Connect the ‘CALsys 1500BB’ to a suitable power supply. ON the Mains switch located at back
side with power entry.
3. set the desire temperature value in PID by using UP & Down key.
4.
Aim the reference (Master) standard infrared temperature sensor to the target area.
5.
PV (Present value) display in controller will gradually rise until it reaches the set point
temperature. The controller takes some times to reach the set-point depending on the span.
Furnace is stable when PV is equal to SV (Set Value).
6.
Master sensor take some times to reach the setpoint temperature and stable at temperature
near about controller set temperature.
7.
When temperature of the master and UUC (Unit under calibration) are stable record the
readings of master sensor.
8.
Compare the UUC reading with the master’s reading & find out the error by comparison method.
9.
Reset the controller and / or repeat the calibration for another calibration point or for another
sensor.
10.
When the calibration is complete, reset the controller to 0°C & wait until the unit has cooled to
below 100°C, before moving the ‘CALsys 1500BB to new location the ‘CALsys 1500BB’ must be
cooled below 100°C before it can be put back into its carrying case.
11.
NOTE: Always use a reference IR thermometer for comparison calibration method.
Note:
All other controller parameters are company set and locked. It is
recommended not to change them.
When the source is operated at any temperature above ambient,
the front face and plate become hot. UP
Key
Down
Key