KEH-10150
Hydraulic Crimping Tool
www.grupotemper.com
6)
Prevent-slip handle
7)
The built-in safety valve to protect the tool and the operator
The built-in safety valve is tested before shipment, the user can not adjust by
yourself, please send the tool to the professional trained person to adjust, then use
the tool.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein before set up
or use of this product.
Any parts of the tool cannot be knocked; the tool is dangerous when the parts is
broken.
1.
Select the appropriate die set for the connector and cable being used. Ask an
authorized facility or distributor to choose proper compression die set for the
connector and cable being used.
Don’t operate the tool without dies.
2.
To insert the dies, open the yoke by pushing out the latch. Push the upper die into the
yoke. Insert other down die into the die holder in the same manner. The steel ball
located center of the die will match the hole of the yoke and die holder when both
die halves are in place.
3.
Make sure both die halves are secured before operating the tool.
4.
Place the connector between the dies, push the yoke in to close the yoke and latch.
Pump the tool handle until the connector is held in place. In this process, spring
loaded pump handle automatically opens by itself for one hand pumping operation.
