Page
2
of
44
Warning Symbol
This document contains notices that you should observe to ensure your own personal safety, as well as to
protect the product and connected equipment. These notices are highlighted in the manual by a warning triangle and
are marked as follows.
The danger symbol indicates that death or severe personal injury may result if proper precautions are not taken.
Do not proceed beyond a warning symbol until the indicated conditions are fully understood and met.
Preface
Original equipment manufacturer reserves the right to change information available in this document without
notice. Manufacturer is not liable for any damages incurred to equipment/personal during installation or use of
equipment as explained in this document. User must acquire sufficient knowledge & skills prior to using equipment in
the application and follow all the local standards & regulations to meet safety requirements.
Copyright
The documentation and the software included with this product are copyrighted 2018 by Tempco Electric
Heater Corp. All rights are reserved. Tempco Electric Heater Corp. reserves the right to make improvements in the
products described in this manual at any time without notice.
No part of this manual may be reproduced/copied/translated or transmitted in any form or by any means
without the prior written permission of Tempco Electric Heater Corp. The information we supply is believed to be
accurate and reliable as of this printing. However, we assume no responsibility for its use.
Warning!
Failure of devices such as the thermocouple/RTD sensor, heater output relay or temperature control may result in
severe damage to a product while in process, melting of the heater or a damaging fire. A latching over-temperature
protection device such as a Tempco model TEC-910 or TEC-410 high-limit controller with manual reset must be
installed in your process. This device should remove power to the heating circuit if the above failure occurs. We
recommend this device be classified as a safety control and carry FM, U.L/CSA Listing or certification. Failure to
install high-limit protection where a potential hazard exists could result in damage to equipment, property and possible
severe injury to personnel.
Содержание TEC-2400
Страница 20: ...Page 20 of 44 2 3 2 TEC 9400 Terminal Connection 2 3 3 TEC 8400 TEC 4400 Terminal Connection...
Страница 21: ...Page 21 of 44 2 3 4 TEC 8450 Terminal Connection 2 3 5 TEC 7400 Terminal Connection...
Страница 22: ...Page 22 of 44 2 3 6 TEC 6400 Terminal Connection 2 4 Wiring Example Contactor...
