11
TO TURN OFF GAS TO THE APPLIANCE
Depress the control knob slightly and turn it
Clockwise
to the OFF position.
Refer to Figure 9.
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When
lighting the pilot, follow these instructions exactly.
B. BEFORE OPERATION smell all around the appliance area for
gas. Be sure to smell next to the floor
because some gas is heavier than air
and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do
not use any telephone in your building.
•
Immediately call your gas supplier from a neighbor's telephone.
•
Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never
use tools. If the knob will not push in or turn by hand, don't try to
repair it. Call a qualified service technician. Force or attempted
repair may cause a fire or an explosion.
E. Do not use this appliance if any part of it has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system or gas
control which has been under water.
PIEZO
Figure 8
LIGHTING INSTRUCTIONS
Release the control knob. If the knob does not pop up when
released, stop and immediately call your service technician.
If the pilot will not stay lit after several tries, turn the gas
control knob to OFF and call your service technician or gas
supplier.
When the pilot remains lit, turn gas knob
counterclockwise to the HIGH position.
Depress the knob slightly and turn
counterclockwise to the
setting you
prefer.
The front burner may be turned on
or off. Turn knob located on right
hand side of the control panel to
“ON” or “OFF” position. Do not
leave in an intermediate position.
This appliance is fitted with a
transient pilot burner for the sole
purpose of safe, momentary ignition of the main burner in
conjunction with the piezo ignitor. When in operation with the
main burner it contributes to the base heat release and is
turned off by turning the control knob to the OFF position.
The control knob should not be left at the ignition setting
after the pilot has been ignited.
1. STOP!
Read “FOR YOUR SAFETY READ BEFORE LIGHTING”
before proceeding.
2. Refer to figure 9.
To turn off the gas
supply, depress the knob slightly and turn
clockwise to the OFF
position.
3.
Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP! follow “B”, in the
safety information above. If you don’t smell
gas, go on to the next step.
4. Refer to figure 10.
Locate the pilot. It is in the center of the back
burner.
5.
Refer to figure 11.
Push in the control knob and turn
counterclockwise to the
PILOT position.
Hold the control knob in for a few
seconds
6.
While still holding in the control knob,
press the ignitor push-button several
times. This will cause a spark at the pilot
which will ignite the pilot gas.
Refer to figure 11.
Hold the control knob for 20 seconds to prevent the
flame failure detector from shutting off the gas while its probe is
Figure 9
Figure 11
Figure 10
Figure 7
OFF