WARNING: Failure to position the parts in
accordance with this diagram or failure to use only
parts specifically approved with this heater may
result in property damage or personal injury. See
instruction manual for further information.
If you connect
natural gas to an LP gas unit,
you may be
unable to ignite the pilot. If the pilot does ignite, the front
burner flame on the low setting will be bright blue but only
1/4” to 1/2” long and most likely lifting off the burner ports. If
this is the case, turn the unit off immediately and contact the
dealer where the unit was purchased.
If you connect
LP gas to a natural gas unit,
the front
burner flame on the low setting will be about 6” - 8” long. On
the medium and high setting, the front burner flames will be
bright yellow and about 10” in length. Turn the unit off
immediately! If the unit is allowed to run in this condition,
substantial amounts of soot will be generated and emitted
into the house. contact the dealer where the unit was
purchased.
POSITIONING LOGS
1.Unpack and identify the four (4) logs by referring to Figures
6A, 6B and 6C.
2.Position back log into “V” log retainers ensuring that back
grate uprights are positioned in log notches.
3.Position front log with front grate bars fitting into log notches.
Log must fit down onto grate bars. (No gap under log).
4.Position middle log so notches in log fit snugly onto log
retaining bars.
NOTE:
Pin on left hand side of grate prevents
log from moving forward which would create flame
impingement from the yellow flame burner.
5. Position log retaining clip parallel with back edge of
middle log. Push pointed end of clip into log and fasten
clip to bar with screw provided.
NOTE:
This clip
maintains upright position of middle log to optimize
glowing ember front surface. (See clip location in Figure
6A).
When you have completed these steps, compare log
positions with Figure 6A. The logs must be positioned as
illustrated.
The top twig may be positioned as shown in either Figure
6B or Figure 6C.
The top twig must be placed in the notches provided on top
of the rear and center logs. The front of the top twig is to
rest of the large knot on the front log.
Caution:
Proper location is critical. When positioning the
log set, make sure that the logs do not interfere with the
sides of the fireplace before securing the chassis.
FIREPLACE SCREEN
A fireplace screen must be in place when the appliance
is operating and unless other provisions for combustion air
are made, the screen must have openings for the
introduction of combustion air.
DECORATIVE VOLCANIC ASH
The volcanic ash from the bag provided should be sprinkled
around the base of the logset
DO NOT
place
any material, including volcanic
ash on burner, pilot or logs .
WARNING
DANGER OF PROPERTY DAMAGE,
BODILY INJURY OR DEATH.
NEVER USE A MATCH OR OPEN FLAME TO TEST FOR
LEAKS. NEVER EXCEED SPECIFIED PRESSURES FOR
TESTING. HIGH PRESSURES MAY DAMAGE THE
APPLIANCE REGULATOR WHICH WOULD REQUIRE
REPLACEMENT. LIQUID PETROLEUM (L.P.) IS HEAVIER
THAN AIR AND IT WILL SETTLE IN ANY LOW AREA,
INCLUDING OPEN DEPRESSIONS AND IT WILL REMAIN
THERE UNLESS AREA IS VENTILATED.
NEVER ATTEMPT START-UP OF UNIT BEFORE
THOROUGHLY VENTILATING AREA.
10
Figure 6A
Figure 6B
LOG POSITIONING - TOP VIEW
(ALTERNATE)
TWIG TOP POSITIONING - TOP VIEW
Figure 6C
WARNING: Failure to position the parts in
accordance with this diagram or failure to use only
parts specifically approved with this heater may
result in property damage or personal injury. See
instruction manual for further information.
LOG
RETAINING
CLIP