26
Temco DV5200, DV6400DSN/DSP Series
77794
1. STOP! Read the safety information above.
2. Set the thermostat, if used, to the lowest
setting.
3. Turn off electric power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the burner.
Do not try to light the burner by hand.
FOR YOUR SAFETY READ BEFORE LIGHTING
B. Use only the wall switch or remote control switch
to turn the gas control on/off. Never use tools. If
the knob will not push in or turn by hand, do not
try to repair it, call a qualified service technician.
Applying force or any attempted repair may result
in a fire or explosion.
C. Do not use this fireplace if any part has been
under water. Immediately call a qualified service
technician to inspect the heater and to replace
any part of the control system and any gas
control which has been under water.
A. BEFORE LIGHTING smell all around the heater
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any fireplace
•
Do not touch any electric switch
•
Do not use any phone in your building
•
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call
the Fire Department
To Turn Off Gas to Heater
Lighting And Operating Instructions
1. Set thermostat to lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
Lighting Instructions
WARNING:If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
ON
OFF
5. Open the access door located at the bottom of
the appliance to expose the controls.
6. Turn gas line valve to “ON”. (Fig. 38)
7. Wait five (5) minutes to clear out any gas, then
smell for gas, including near the floor. If you
smell gas, STOP! Follow “A” in the safety
information above. If you do not smell gas, go
to the next step.
8. Replace control access panel.
9. Turn on all electric power to the appliance.
10. Set thermostat to desired setting (if available).
11. If the appliance will not operate, follow the
instructions “To Turn OFF Gas to Appliance”
and call your service technician or gas supplier.
3. Open the control access door.
4. Turn gas line valve to the “OFF” position.
5. Close the control access door.
Fig. 38
