3
Temco DV5200, DV6400DSN/DSP Series
77794
This gas appliance should be installed by a qualified installer
in accordance with local building codes and with current CSA-
B149.1 Installation codes for Gas Burning Appliances and
Equipment. For U.S.A Installations follow local codes and/or
the current National Fuel Gas Code. ANSI Z223.1/NFPA 54.
This appliance, when installed, must be electrically connected
andgrounded in accordance with local codes or, in the
absence of local codes, with the current CSA C22.1 Canadian
Electrical Code or with the National Electrical Code: ANSI/
NFPA 70-1987 when installed in the United States.
FOR SAFE INSTALLATION AND OPERATION
PLEASE NOTE THE FOLLOWING:
1 . This fireplace gives off high temperatures and should be
located out of high traffic areas and away from furniture
and draperies.
2.
Children and adults should be alerted to the hazards of
the high surface temperatures of this fireplace and should
stay away to avoid burns or ignition of clothing.
3.
Children should be carefully supervised when in the same
room as your fireplace.
4.
Under no circumstances should this fireplace be modified.
Parts removed for servicing should be replaced prior to
operating this fireplace again.
5.
Installation and any repairs to this fireplace must be
performed by a qualified installer, service agency or gas
supplier. A professional service person should be con-
tacted to inspect this fireplace annually. Make it a practice
to have all of your gas fireplaces checked annually. More
frequent cleaning may be required due to excess lint and
dust from carpeting, bedding material, etc.
6.
Control compartments, burners and air passages in this
fireplace should be kept clean and free of dust and lint.
Make sure the gas valve and pilot light are turned off
before you attempt to clean this fireplace.
7.
The venting system (chimney) of this fireplace should be
checked at least once a year and if needed your venting
system should be cleaned.
8.
Keep the area around your fireplace clear of combustible
materials, gasoline and other flammable vapor and liquids.
This fireplace should not be used as a drying rack for
clothing, nor should Christmas stocking or decorations be
hung in the area of it.
9.
Under no circumstances should any solid fuels (wood,
coal, paper or cardboard etc.) be used in this fireplace.
10. For safe operation, the glass door must be closed.
11. Do not use this heater if any part has been under water.
Immediately call a qualified service technician to inspect
the heater and to replace any part of the control system
and any gas control which has been under water.
12. Do not operate appliance unless completely installed as
per installation instructions.
13. This appliance may be used in a bedroom installation.
Install in accordance with local building codes and
regulations.
14. Never use your fireplace as a cooking device.
15. This appliance must not be connected to a flue serving a
solid fuel burning appliance.
Installation & Operating Instructions
This appliance may be installed in an aftermarket
permanently located, manufactured home or mobile
home, where not prohibited by local codes.
This appliance is only for use with the type of gas indi-
cated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified
kit is used.
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
Remove any plastic from trim parts before turning the
fireplace ON.
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found
with your furnace heat exchanger or car engine. It is
not unusual for your Temco Fireplace Products gas
fireplace to give off some odor the first time it is
burned. This is due to the manufacturing process.
Please ensure that your room is well ventilated
-open all windows.
It is recommended that you burn your fireplace for at
least four (4) hours the first time you use it. If the
optional fan kit has been installed, place the fan switch
in the “OFF” position during this time.
The embers supplied with your fireplace are made
from a high grade rock wool and should be
handled carefully. Wash your hands immediately
after touching to avoid irritation. The embers must
be placed correctly in order to function properly.
WARNING: When purging the gas line, the glass
front must be removed.
