TEMA TELECOMUNICAZIONI
IP PoE Multicast Encoder
AD615/SIP
MAS-AD615SIP-REV00EN
Page 15 of 28
Once the correct connection is identified, click on it and it will appear the window where it is necessary to click on
the "Properties" button. It will then open the window where must be selected "Internet Protocol Version 4
(TCP/IPv4)" and then click the Properties button again. See the following figures:
If the PC is already on subnet 192.168.0.x with a mask 255.255.255.0, ignore the following steps. Otherwise,
proceed as follows. (The address of the PC configuration should not be 192.168.0.10).
Remember the current TCP/IP configuration of your computer for any subsequent restore of the correct
parameters.
Click "Use the following IP address" and type in the appropriate field the following IP address: 192.168.0.11
(instead of "11" used in the example it is possible to enter any number between 1 and 254, but excluding the 10
which is the default address of the system to be programmed). In the "Subnet Mask" enter the netmask
255.255.255.0. Click OK to confirm the changes. The PC is now ready to configure the door phone. Remember at
the end of programming to restore the network configuration of the PC to its original state if necessary.
Once the IP address of your PC is successfully configured, it is possible to reach the Web interface to configure
AD615/SIP at the address 192.168.0.10 .
