56044702 18
© 2012 Telular Corporation
Connect Alarm Panel to TG-1 Express
If the alarm panel and the TG-1 Express were not already connected in
Step 2, plug the modular jack of the alarm panel to the RJ-45 jack on
the Telguard.
Set Up & Program the Operating Parameters in the
Telguard
When the Telguard is received from the factory and is powered up for
the first time, it is immediately ready for activation, provided the
default settings are what you want. The STC LED #2 will flash to
indicate any failure conditions. If changes are required to the default
settings, the Telguard can be programmed using a line-man’s butt-set
connected to T & R Test Points or a POTS phone connected to the RJ-
45 jack (where the alarm panel is normally connected).
Key Sequence
Description
###
*
Enters the programming mode
#* Begins
programming
*
Saves and stores changes
Command Key Sequences for POTS Programming Table
To Program the Telguard:
1.
Make sure the Telguard has finished initialization and is
idle.
2.
Connect a POTS phone or lineman’s butt set on the alarm
panel jack (J11).
3.
Take the POTS phone off hook or put the butt set in talk
mode. You should hear dial tone.
4.
Dial ###*, and you should hear two (2) beeps.
5.
Dial #*, and you should hear two (2) beeps.
6.
Dial the memory location number (8XX) to be changed;
you should hear two (2) beeps.
7.
Enter the data value; you should hear two (2) beeps.
