56044702 17
© 2012 Telular Corporation
check the signal strength. If the signal strength is OK, then call
Technical Support.
Important:
In order to clear the faults listed above, the RSSI
button must be pressed twice. After the issue has been
resolved and the unit cleared, STEP 3 MUST BE REPEATED OR
THE TELGUARD WILL NOT TRANSMIT ANY SIGNALS.
System Status LEDs
Activation Indications
ALL LEDS FLASHING
Failed Activation – Signal Too
Weak
LED #1 & LED #4 FLASHING
Activation Error – Call
Telguard Technical Support
LED #1 ON
Activation Successful
System Status LEDs Table
If no LEDs besides the power LED are lit or flashing, it may
indicate insufficient power supplied from the alarm panel.
Press the RSSI button to change the LEDs to RSSI mode. If still
no LEDs are lit, then check the voltage being supplied to the
Telguard, and ensure that it is above 6.2V.
Status LED #2
Indication
1 FLASH
STC – Low Power Failure
2 FLASH
N/A
3 FLASH
N/A
4 FLASH
NSC – No Service
5 FLASH
RFC – Radio Failure
6 FLASH
DTF – Dial Tone Failure
7 FLASH
PPF – Panel Presence Failure
System Trouble Condition, STC (LED #2) Table
