Phonecell
®
SX5T CDMA
2
User Manual
SX5 Location and Installation
The SX5 comes with a standard spike antenna (TNC)
- see Figure 5
. For optimal signal
strength, choose a location that is above ground and as close to windows (or exterior walls) as
possible
- see Figure 6
. Cellular signal strength is displayed by the Received Signal Strength
Indicator (RSSI) LED on the unit - See the
How to Use the LED Status Indicators
section of this
manual.
1. Connect the antenna to the terminal
- see Figure 5
.
2. Finger-tighten the antenna. Do not over-tighten the antenna.
Wall Mounting
1. Mark two hole locations 98,5 mm (3-7/8 inches) vertically apart and drill two holes into the
wall.
2. Install the screws (not supplied) into the wall, leaving a gap (approximately 3 mm (1/8 inch))
between screw head and wall.
3. Align the mounting holes with the screws and mount the SX5 onto the screws -
see Figures
7 and 8
.
Figure 6 –
Typical SX5 installation.
Wall Mount
Figure 5 –
SX5 antenna connection.
Spike
antenna
TNC Antenna
Connector
Table Mount
Figure 7 –
SX5 mounting holes.
Figure 8 –
Mount the SX5 onto the screws.
Mounting Holes
98,5 mm (3 7/8”)
