18
18
7.6 Configuration through GPRS and CSD
WirelessCom/G10 can also be configured through a remote computer if there is an
established GPRS or CSD connection between WirelessCom/G10 and the PC. All the commands
(except
test
) and configuration parameters are supported. Configuration through GPRS/CSD will be
the same as if you were directly connected to WirelessCom/G10. However there is one change, every
command should start with
*
and finish with
#
.
Nr.
Parameter
Syntax
1. MODE
*set mode xxx#
*get mode#
2. TCP CONNECTION TIMEOUT
*set tcp_connection_timeout xxx#
*get tcp_connection_timeout#
3. BAUD
RATE
*set baud xxx#
*get baud#
4. DATA
FORMAT
*set data_format xxx#
*get data_format#
5. PIN
*pin
xxx#
6. PUK
*puk
xxx#
7. BEARER
*set bearer xxx#
*get bearer#
8. PING
*set ping xxxx#
*get ping#
9. BUFFER
SIZE
*set buffer_size xxx#
*get buffer_size#
10. BUFFER
TIMEOUT
*set buffer_timeout xxx#
*get buffer_timeout#
11. CALL
TYPE
*set call_type xxx#
*get call_type#
12. USER
NAME
*set username xxx#
*get username#
13. USER
PASSWORD
*set userpassword xxx#
*get userpassword#
14. AUTHENTICATION
PROTOCOL *set auth_protocol xxx#
*get auth_protocol#
15. LOCAL
PORT
*set local_port xxx#
*get local_port#
16. SERVER
IP
*set server_ip xxx#
*get server_ip#
17. SERVER
PORT
*set server_port xxx#
*getserver_port#
18. BEARER CONNECTION TIMEOUT *set bearer_connection_timeout xxx#
*get bearer_connection_timeout#
19. APN
*set apn xxx#
*get apn#
20. BEARER
PHONE
*set phone xxx#
*get phone#
21. AUTHORIZED PHONE NUMBER
*set auth_phone xxx#
*get auth_phone#
22. DEVICE
ID
*set device_id xxx#
*get device id#
