12
12
The setup for configuration is ready now, however if you want to see the characters which you are
typing on hyper terminal, proceed to next steps,
5.
In the
File
menu choose
Properties
and
Settings
. In the opened window choose
ASCII
Setup
.
6.
Switch on (see Figure 7.2.2):
ª
Send line ends with line feeds
.
ª
Echo typed characters locally
.
Figure 7.2: ASCII Setup window
Click
OK
.
7.3 Entering into configuration mode
1.
Click the button
Call
on Hyper Terminal toolbar.
2.
Power-up WirelessCom/G10 from the AC/DC adapter.
3.
When the status LED starts to blink green (device initialization) press and hold spacebar on the
Hyper Terminal window, until a message: “Welcome to WirelessCOM/G10 Configuration
console. Firmware version: xx.xx.xx” appears. LED will blink green and yellow alternately to
indicate configuration mode.
* Once WirelessCom/G10 is powered-up, for the initial 8 seconds it is waiting to see if user
wants to enter into configuration mode or not. Once these 8 seconds are elapsed you cannot
enter configuration mode, you would need to restart the device.
7.4 Command set
Now you can use the commands for a full configuration of the device. To see all the
available commands enter
help
command in configuration console and you will get a list of commands
with their short description. The commands are described in brief below,
1) get:
This command will give you the information about configuration parameters
of WirelessCom/G10. If you need information about all the parameters, just type
get
and press enter/return key. To get the information about individual configuration
parameter, type
get xxxx
where xxxx is the name of configuration parameter, and
