13
13
press enter/return key.. For example,
get mode
this command will give you the
information about the mode in which WirelessCom/G10 is configured.
2) set
: This command performs 2 functions,
a) It gives you the information about all the configuration parameters and their valid
values. To get this info, just type
set
and press enter/return key.
b) This command is also used to enter the values of configuration parameters. Type
set xxxx yyyy
and press enter/return key, where xxxx is the configuration parameter
name and yyyy is the value of configuration parameter. For example
set bearer gprs
this command will choose the bearer type as gprs.
3) test:
Once you have configured all the necessary parameters, you can use this
command to check if the settings are fine and if WirelessCOM/G10 is able to make
connections using GPRS/CSD bearer. If test is used for CSD bearer,
WirelessCOM/G10 will try to connect to the number configured in csd_phone.
Therefore make sure that the phone number is correct and ensure that csd_phone will
answer the call from WirelessCOM/G10. If test is used with GPRS bearer in master
mode, then WirelessCOM/G10 will try to activate gprs and connect to the configured
ip address and port. When the GPRS connection with server is established
WirelessCom/G10 will make a small data transfer (all the information about
configuration parameters) and then close the connection.
4) clear:
This command is used to clear the values of string parameters. These
parameters include username, userpassword, device_id, password, apn, auth_phone1,
auth_phone2, auth_phone3, auth_phone4, csd_phone. To clear a particular value, type
clear xxxx
where xxxx is the name of configuration parameter, and press enter/return
key, for example
clear username
You can clear all the string parameters and some
numerical parameters in one time by typing
clear all
If you will type only
clear
and
press enter/return key, it will show you the parameters which can be cleared by using
this command.
5) restart:
This command is used to restart WirelessCOM/G10. Type
restart
and
press enter/return key.
6) pin:
If you have a sim card with enabled pin, WirelessCOM/G10 gives you the
possibility to enter the pin (of sim card) automatically each time the device restarts.
