Teltonika GH4200, Руководство для продвинутых пользователей

Страница: 70 / 73

70
Structure of the message is similar to one when configuration is made using terminal. You must follow these rules in
order to change configuration:
1. Maximum length of the message – 160 characters;
2. Every command in the same line is separated by semicolon (;);
3. Command must be separated from parameter with colon (:);
4. Parameters must be separated with comma (,);
5. In order to delete commands parameters type (~) symbol;
6. Last command must be RST (RESET, device must to reset in order to work with new configuration);
7. It is not allowed to split command message in other two (first message has begging and other end).
Advanced configuration text message looks like this:
psw:<password>;CFG1;<command>:<
parameter1
>,<parameter2>,<parameter3>;RST
Example:
psw:0000;CFG1;GPS:1,130,300,1;RST
Device will respond with SMS message after successful change of configuration.
Configuration using terminal
Device configuration can be changed using Terminal (software which communicates with device through command
line). Detailed description is described in General Protocol Configuration document. Terminal software can be
downloaded from here: http://avl1.teltonika.lt/downloads/GH4000/Software/Terminal.
Main configuration steps:
1) Connect device to computer;
2) Choose COM port, to which device is connected to;
3) Press Open in order to connect device with computer;
4) Send command with device configuration password: #GH+PSW=0000;
5) Read device parameters: #GET:CFG1 ;
6) Send command with new parameters. Commands and parameters will be found in General Protocol
Configuration document;
7) Save changed configuration: #SAVE:CFG1;
8) Reset GH4200: #RST. Device can be reset by pressing reset button too. Device has to be disconnected and
connected again to computer via USB port in order to use terminal after reset.
Notice! Device will respond OK to correctly sent commands.