Teltone TLS-3B, Руководство пользователя

Страница: 15 / 24

TLS-3B User’s Manual
40-400-00032, Rev. B 9
Follow these steps to enter Programming Mode:
1. Lift the handset on one of the telephones.
2. When you hear dial tone, enter **99## for Setup 1 mode, or **98## for
Setup 2 mode.
You hear three short beeps verifying proper program mode access. The Power
LED blinks once for Setup 1 and twice for Setup 2.
When you enter a programming command correctly, you will hear three short tones
(confirmation beeps). If you enter an incorrect command, you will hear alternating
high and low tones (error beeps).
A summary of programming commands is provided on page 17.
System Commands
Programming Mode
To enter programming mode from Line 1 or Line 2:
Setup 1 **99##
Setup 2 **98##
Reset
This command resets all options to the factory defaults, both Setup 1 and Setup 2.
*00#0#*00#0#
Tone Following Disconnect
These commands define the type of tone a caller hears when the other line
disconnects:
Dial Tone *04#0# (default)
Busy Signal *04#1#
Reorder Signal *04#2#
Silence *04#3#
Forced Disconnect (COD) Duration
This command sets the time duration of the line break to the off-hook device. The
time specifies the number of 50 mS increments. The range is from 0 to 100 (100 = 5
seconds). For example, to set disconnect to 850 mS (default), use 17 X 50 = 850 mS).
*05#time#