Teltone TLS-3B, Руководство пользователя

Страница: 16 / 24

TLS-3B User’s Manual
40-400-00032, Rev. B 10
Cut-off on Disconnect Delay
This command sets the amount of time after the called party hangs up until the calling
party is sent the forced disconnect signal (COD). The time specifies the number of
100 mS increments. The range is from 11 (1.1 seconds) to 200 (20 seconds) and the
factory default is 2 seconds, i.e., *06#20#.
*06#time#
Ringing Frequency
This command defines the frequency of the signal that the TLS-3B will use as a
"RING".
20 Hz *07#0# (default)
25 Hz *07#1#
Hook-flash Detect
When Hook-flash detect is active, the TLS-3B will detect a switchhook flash after the
other line has answered. The TLS-3B will return dial tone and allow the user to dial
test numbers or one of the port numbers.
Disable Hook-flash Detect *10#0# (default)
Enable Hook-flash detect *10#1#
Line Attenuation
This command defines the signal loss of the talk path from one line to the other. This
command also affects the level of the call progress signals, e.g. Dial Tone, Busy,
Reorder, and Ringback.
Set attenuation to 6 dB *09#0# (default)
Set attenuation to 16 dB *09#1#
Test Numbers
These commands define the test telephone numbers. The name of the tone indicates
the type of signal you will hear when you dial the number. Test numbers may be up to
16 digits long. Valid digits are 0-9.
Dial Tone
Default = 83781 (Test 1)
*60#number#
Busy Signal
Default = 83782 (Test 2)
*61#number#
Reorder Tone
Default = 83783 (Test 3)
*62#number#
Ringback Tone
Default = 83784 (Test 4)
*63#number#
Silence
Default = 83785 (Test 5)
*64#number#