Voice Gateway 4FXS User Manual
- 73 -
或
protocol_ep1> mgc3 {parameter1} [parameter2]
Its usage is the same as the “mg” command.
Command of H.248 permission mode setting
protocol_ep1> trans_type {parameter}
The parameter is only “tcp” or “udp”.
Command for setting H.248 signaling abbrev-mode
protocol > sig_ab_mode {parameter}
The parameter is only “enable” or “disable”. “enable” means to open it, and
“disable” means to close it.
Command for setting H.248 temporary endpoint
protocol > ephterm
The command is set by mode of interaction, it does not need any parameter. After
carrying out the command, CLI will require users to set relevant parameters. Direct
buttoning of the enter key by users will keep the original set value, and buttoning
“Ctrl ＋ C” can cancel the settings. For instance:
protocol_ep1> ephterm
Ephterm Prefixion [RTP/]:
Start NO. [0]:
Ephterm Max Number [10000]:
Ephterm Step [1]:
Ephterm Name same length [n] (y/n)?
Command to set H.248 command re-sending time
protocol_ep1> resend_time {parameter}
