Voice Gateway 4FXS User Manual
- 69 -
Once input “network” command in the root command layer, you could go to
network parameter setting content, for example, ＃network
If the network setting is based on the unit of connection, every connection can be set
different network configurations.
Add connection#network> add connection {parameter}
Parameter is the identifier of connection which is going to be added. After adding
connection, you could go into the corresponding connection to set related
parameters.
Go into the corresponding connection
#network> connection {parameter}
Parameter is the identifier of connection which is going to be gone into. You could go
into the corresponding connection to set related parameters, including IP, VLAN and
the like.
Example: #network> connection connection1
Setting of the physical port for connection
# network/conn connection1> set phyport {parameter}
Parameter is the physical port. There are two physical ports on the device, one is FEO,
the other is FE1. So parameter’s value is fec0 or fec1.
Setting of connection static network mode
#network/conn connection1> set ip static {parameter1} {parameter2}
Parameter 1 is the IP address that will be set, and parameter 2 is netmask.
Setting of connection dhcp network mode
#network/conn connection1> set ip dhcp
There is no need of any parameter when setting connection dhcp network mode, just
