SECTION 3 |
3
3
Installation
Before You Begin…
Your new Telos VSet phone is designed for fast, intuitive control of Telos VX Engine, iQ6, and Hx6 Talkshow Systems.
Please configure your Telos phone system according the instructions in the User Manual before connecting your VSet to
the network.
VSet phones receive 48-volt power through their Ethernet connection, allowing PoE (Power over Ethernet) to be
supplied by Ethernet switches equipped to provide it. Note that this uses 15.4 watts of your switch’s PoE power. If your
Ethernet switch does not have PoE capability, please use the PoE injector included with your VSet. The PoE injector is also
required for non-switched direct connections to the Hx6 Digital Talkshow System.
Connect Your VSet
First, determine whether your system’s Ethernet switch provides PoE. If so,
connect one end of the supplied Ethernet cable to one of your switch’s PoE-en-
abled ports, and the other to your VSet.
If your switch does not have PoE capability, connect the included PoE Injector to
the switch via the Data In jack. Connect your VSet to the Data & Power Out jack
and plug the injector into an AC power outlet.
A direct, non-switched connection between the Hx6 and a VSet is possible with-
out use of a cross-over cable. Standard Ethernet cables from the HX6 between the
PoE power supply and both the Hx6 and VSet are acceptable.
The LED indicators near the VSet connection port should show solid green (good connection); the yellow LED should be
flashing, indicating data flow. After a few seconds, the VSet’s LCD screens will light. If they do not, check the connection
of the PoE Injector and / or Ethernet cable.
