InSTallaTIOn anD COnfIGuraTIOn |
11
They normally do not include the area code.
In some cases, you may need to enter 10 digits for your DNs.
Click “
Apply
”, then “
Reboot Now
” to activate the ISDN circuits.
Successful initialization of a line will be indicated by the idle line state on the front display of the iQ6. This
state is shown with a single dot for each active line in the center row of the front display.
The same indicator is also available on the Status page of the web interface.
4 active lines shown initialized
Tips
Incorrectly entered SPIDs are the most common problem users in the USA & Canada have
when placing ISDN calls. Compare the SPIDs you have entered with the SPIDs provided to
you by the phone company to be certain that you have entered them correctly. Do not add
anything to your SPIDs. Note that there are no hyphens, dashes (-), or spaces in SPIDs so the
system will not allow you to enter any non-numeric characters. If your installer has included
them in the SPID, ignore them.
If you have PTP (AT&T Point-to-Point) or ETS300 (Euro-ISDN) ISDN protocol, you should not
enter anything in the SPID fields.
If you experience problems only with incoming calls, check your DNs.
2.4 Client Configuration
There are three different clients which can connect to the iQ6. The client limit connection is twelve.
♦
Axia iQ surface (2.4.1)
♦
VSet (2.4.2)
♦
VX Producer (2.4.3)
2.4.1 Axia iQ Surface client
For details on the Axia iQ console, please refer to the appropriate documentation for the product. This
section is here to assist with interfacing iQ6 to your iQ console..
Connect to the iQ console’s web interface and select a Show Profile. The Show Profile page has Phone
Connection settings to be filled in.
♦
Phone Server IP:
Enter in the user name, password, and IP address of the iQ6 in the following format:
♦
User:
[email protected] ([email protected])
♦
Studio Name:
Enter “Hybrid 1&2”
♦
Show Name:
This is used for TelosVX systems and may be left blank
