7
TSTFR
X
=
frequency
#
Setting the supervision test report sending frequency
assigned to IP addresses: substitute "X" with the ordinal
number of the IP address. The frequency value should be
entered in seconds.
AUTOIP=
dialed number
#
Setting the number dialed by the alarm control panel for
the “
Automatic IP selection
”
option.
SELFID=
SIA user ID
#
Sets the SIA user ID.
GSMS=
Y
#
Sets the
„GSM call filtering”
option.
Y=0 (call filtering disabled)
Y=1 (call filtering enabled)
SPH
X
=
phone number
#
Setting the phone numbers for backup GSM voice call
filtering: substitute "X" with the ordinal number of the
DTMF receiver phone number to be set or modified.
SFW=
phone number
#
Sets the phone number where incoming SMS messages
will be forwarded.
FWVER?#
Module firmware version query.
TROUT?#
Querying outgoing data traffic counter. The value in the
response message is specified in Bytes.
TRIN?#
Querying incoming data traffic counter. The value in the
response message is specified in Bytes.
TRALL?#
Querying total data traffic counter. The value in the
response message is specified in Bytes.
GMIC=
X
#
Adjusts the microphone volume (outgoing Contact ID
volume).
Substitute X with a number between 0…15.
Default setting: 3.
GSPK=
X
#
Adjusts the speaker volume (incoming HSK/ACK volume).
Substitute X with a number between 0…100.
Default setting: 50.
Configuring commands must always end with hash "
#
" character. It is also possible to
send multiple commands in one SMS, but the message must not exceed 160 characters.
If the response SMS to be received from the module would exceed 160 characters, only
the first 160 characters are sent. In case of making typing or command mistakes, the
following response SMS will be received: "
SYNTAX ERROR!
" and the command(s) will
not be executed. The module accepts SMS commands sent from the
Superuser
phone
number only.
Deleting settings:
To delete a setting, do not enter any value after the equality sign. This can be applied for
all configuring commands found in the spreadsheet above. Example:
PH2=#
: deletes the second dialed number assigned to the second IP address
IP3=#
: deletes the third IP address
SPH3=#
: deletes the third backup GSM phone number
SFW=#
: deletes the SMS forwarding phone number
