8
2.3 Structure of SMS containing settings
The module can send current settings in SMS (see item 6/1. of the programming menu).
The settings are sent in 2 SMS messages, having the following structure:
Example:
CompactGSM settings (1):
TEL1=06301111111/Y
(
TEL1…TEL4
= the 4 adjustable user phone numbers, after
TEL2=06302222222/Y
the phone numbers the confirmation setting can be found)
TEL3=06203333333/N
/Y
= event must be confirmed from this phone number
TEL4=06704444444/N /N
= event confirmation is not requested from this phone nr.)
M STAT=0615555555
(
M STAT
= monitoring station phone number)
CompactGSM settings (2):
Z1=NO
(input 1 setting:
NO
= normally open)
Z2=NC
(input 2 setting:
NC
= normally closed)
RELTIME=0002
(relay active state duration in seconds)
USER ID=1234
(4 digit decimal user account ID)
EVENT_Z1=130
(Contact ID code of input 1 -
130
=burglary)
EVENT_Z2=130
(Contact ID code of input 2 -
130
=burglary)
EVENT_LOW V=302
(Contact ID code of low supply voltage)
EVENT_TEST=602
(Contact ID code of periodic test report)
TESTDAYS=7
(Automatic test report sending period in days)
LOW V REP=Y
(Supply voltage monitoring setting -
Low
v
oltage
rep
ort:
Y
=enabled,
N
=disabled)
CALLID CHK=N
(Caller identification:
Y
=enabled,
N
=disabled)
2.4 Modification of event SMS texts
If it is needed, the default texts of event SMS messages can be modified by sending
command SMS to the module. The command SMS has to be sent when the module is in
programming mode, therefore it is recommended to write the command SMS prior to
turning the module in programming mode. To turn the module in programming mode, the
program button must be pressed for 3-5 seconds, then released. Thereafter the
command SMS has to be sent within 3 minutes.
Structure of the command SMS:
Event
Command SMS to be sent
Alarm input 1
¾
SMS1=
desired message
#
Alarm input 2
¾
SMS3=
desired message
#
Low supply voltage
¾
SMS5=
desired message
#
Voltage restore
¾
SMS6=
desired message
#
Periodic test report
¾
SMS7=
desired message
#
It is possible to send more commands in one SMS, but each command must start
with
¾
character and respectively end with
#
character, and the length of the whole SMS
must not exceed 160 characters.
Example:
¾
SMS1=Door opening#
¾
SMS3=Indoor alarm#
¾
SMS5=Battery low#......etc.
The module sends response SMS if the modification was successful or if the command
SMS was faulty and therefore the modification failed.
