Telit Wireless Solutions LE915A P Series, Руководство по конструкции аппаратуры

Страница: 43 / 51

LE915Ax-P
Hardware Design Guide
1VV0301680 Rev. 2
Page 43 of 51 2021-10-04
Not Subject to NDA
• LTE band 48 : Max. 0.5 dBi, assuming 0.5 dB attenuation loss between LCC module
pad and antenna SMA connector.
The dipole antenna must be installed such that 20cm can be maintained between the
antenna and users to comply with the FCC maximum EIRP limits and RF Exposure rules.
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: "Contains FCC
ID: RI7LE915A6" or "Contains FCC ID: RI7LE915A4" accordingly. The grantee's FCC ID
can be used only when all FCC compliance requirements are met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-
located or simultaneous transmission with other transmitter(s) or portable use will
require a separate class II permissive change re-evaluation or new certification.
2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the
FCC Part 15 Subpart B (unintentional radiator) rule requirement applicable to the final
host. The final host will still need to be reassessed for compliance to this portion of rule
requirements if applicable.
As long as all the above conditions are met, no further transmitter test will be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed.
IMPORTANT NOTE:
In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), the FCC authorization is no
longer considered valid and the FCC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
Manual Information to the End User
The OEM integrator should be aware not to provide information to the end user on how to
install or remove this RF module in the end product user manual that integrates this
module. The end user manual shall include all required regulatory information/warning
as shown in this manual.