TELink BLE 1x6 Test System 3.2, Руководство по сборке и обслуживанию

Страница: 21 / 46

Assembly And Maintenance Manual for Telink BLE 1x6 Test System 3.2
AN-18071200-E1 20 Ver 1.0.0
2.4 Check Jig debugging
Keeping test consistency is critical for multiple sets of 1x6Jig. During debugging,
it’s needed to select several good products and several rejected products, then test
them on each Site of each Jig; good products should pass test on each Site, and each
rejected product should fail at the same test item on each Site. Take the rejected
products with low RF Tx power for example, the data log is shown as follows:
Site NO Board NO Channel TX Test Offset RX Test IEEE Address
1
star
2392 100/-34 2
2495 9
1st ok
2392 100/-26 6 92/-54
0x8a003a30
2495 100/-26 12 100/-54
2nd ok
2392 100/-29 -9 96/-62
0x8a003a36
2495 100/-27 -4 100/-54
2
star
2392 100/-29 1
2495 100/-32 7
1st ok
2392 100/-23 4 100/-53
0x8a1019ec
2495 100/-25 12 100/-54
2nd ok
2392 100/-23 1 100/-54
0x8a1019f2
2495 100/-25 11 100/-53
3
star
2392 100/-31 -7
2495 100/-32 -1
1st ok
2392 100/-23 -2 100/-53
0x8a203d21
2495 100/-25 4 100/-54
2nd ok
2392 100/-25 -17 100/-54
0x8a203d27
2495 100/-25 -9 100/-54
4
star
2392 100/-32 4
2492
1st ok 2392 100/-25 7 99/-54 0x8a301f13
Telink
for
customer