TELIKOU
MS-800 Eight-Channel Main Station
12
connector on rear panel. The Online connector of this station connected to the
Intercom Line connector of another station.
Solution 1: Check the connection of Online connector.
When connecting those
non-
TELIKOU
main stations to
TELIKOU
main station, must use Intercom Line
Connector. Besides, the Pin-2 of XLR should connect a homopolar capacitor in
series, whose capacity is not smaller than 1μF.
Cause 2: If there is SPK-200 in the system. The Online connector of SPK-200 can
connect to other station’s Intercom Line connector. But Connect To switch of SPK-
200 must be place on Intercom Line position. The setting of Connect To switch is
not correct.
Solution 2: Place Connect To switch on Intercom Line position.
Problem: Can not turn off the Mic function on all the beltpacks after
pressing RMK button
Cause 1: The connection among TELIKOU mains stations must go via Online
connector. If main stations are connected by Intercom Line connector, RMK
function will not work properly.
Solution 1: Check the connection among main stations. Please use Online
connector.
Cause 2: Some stations are not TELIKOU. So these stations do not have Online
connector.
Solution 2: Change to TELIKOU main station.
Problem: The volume of front panel speaker is too weak
Cause: When the front panel speaker is turned on, pressing Mic button will reduce
the speaker output level about 6dB and helps minimize feedback
Solution : Turn off the Mic button after each speaking.
VI Technical Specification
PRE-AMP:
Microphone impedance: Dynamic 200ohm
Gain form Mic to intercom line: +49dB
Bandwidth: 40Hz-8000Hz ± 2dB
POSTPOSITION-AMP:
Load impedance: 50-2000ohm
Output level: +17dBv
Distortion: <0.1% (1000Hz)
