Telic SBC AVL 4G, Руководство пользователя

Страница: 20 / 36

SBC AVL 4G User Manual - Telic AG
Pg 19
This means that a position message is generated and transmitted every 2 km on a freeway or highway
(driving with about 120km/h).
As soon as motion is ended (detected by built-in sensor), the device will go to sleep mode. When
going back to motion (detected by the sensor), the device will automatically resume tracking.
A routine event (“I am alive”) will be sent once a day.
Then the power mode will be motion-sleep mode (
5 ), and time interval 60 sec.
The following extra messages are generated and sent to the server (value= 2 in the 32 bytes sequence
detailed below):

Power Supply connected / disconnected

Ignition signal on / off

Digital Input 2 signal on / off

Digital Input 4 signal on / off

Device stopped moving ( 30 seconds without any sensor motion detection)

Device started moving (according motion sensitivity level 3 )

Periodic Wakeup / Routine message (every 24 hours)
Configuration SMS :
0011{6digitsIMEI},,,,
60 ,0,200000700000, 5 0000009,000000000 2222222 00000000 22 000000,,,,,,0,0,0,0, 24 ,,,,
3 , 30 ,,,,30,6
Configuration command through serial line:
CONFIG=,,,,60,0,200000700000,50000009,00000000022222220000000022000000,,,,,,0,0,0,0,24,,,,3,30,,,,3
0,6
Remark : the “0011{6digitsIMEI}” of the SMS becomes “CONFIG=” in the serial command; the rest remains
unchanged.

Vehicle - Medium Resolution - Off by Motion
Position messages are generated either after 5 km distance or as soon as the driving direction has
been changed more than 45 degrees provided that the vehicle is exceeding 20Km/h.
Driving long distances will be covered by one position message every 5 km, driving short distances is
managed by generating position messages whenever the driving direction is significantly changed.
As soon as the vehicle has stopped (detected by sensor) the device will go to sleep mode. When
vehicle goes back to move, the device will automatically resume tracking.
Power mode: motion-sleep mode (
5 )
Distance interval: 5,000 mt
Course change: 45 degrees
Minimum Speed: 20 Km/h
In addition the following extra messages are generated and sent to the server:

Power On

Ignition signal on / off

Digital Input 2 signal on / off

Device stopped moving ( 1 minute without any sensor motion detection)

Device started moving (according motion sensitivity level 3 )
Configuration SMS:
0011{6digitsIMEI),,,,0,
5000 ,020000700000, 5 0000009, 2 000020000 2222 0000000000 22 000000,,,,,,0,0,0,0,2
4,,,, 3 , 60 ,,,, 45 , 20

Vehicle - Low Resolution Track (10min interval)