Telic Picotrack, Руководство пользователя

Страница: 9 / 24

Picotrack 4G User Manual V1.2
Seite 9
Figure 2: How to insert the SIM Card
The opposite cover of the housing, in which the GPS receiver is embedded, should
not be opened, to avoid a contamination of the receiver which may lead to a
reduction of receiving quality (should you be forced to clean the pad sometime,
please do so using pure alcohol).
Before the Picotrack logs into the mobile GSM network, it checks whether the used SIM card is
PIN free. If it is PIN free, it will start normal operation.
If the SIM card is not PIN free, it has to be assured, that the PIN is set to “0000” before it has been
inserted. The PIN can be changed e.g. with a normal mobile phone to “0000”.
To speed up the log-in into the mobile network, the SIM card should not contain any phone book
entries.
Closing the housing
Make sure that the battery is not damaged or squeezed by the holder of the
housing while closing the device, and that the battery cable is not pinched or
kinked.
Avoid any stress on the micro USB connector when it is plugged in the Picotrack. In
the worst case, the connector of the Picotrack board could be damaged. Telic’s
warranty does not cover the repair of this type of damage.
Close the device again and take care that the housing covers fit together tightly and properly.
Switching the device ON and OFF
To switch the device ON: push the red button until the green LED of the left GSM-indicator
lights up.