Telic Picotrack, Руководство пользователя

Страница: 20 / 24

Picotrack 4G User Manual V1.2
Seite 20
Power mode: input sleep mode ( 1 )
Time interval: 300 sec
Distance interval: 1,000 m
Course change: 30 degrees
In addition, the following extra messages are generated and sent to the server:

Power Supply connected / disconnected

Ignition signal on / off

Digital Input 2 signal on / off

Device stopped moving ( 1 minute without any sensor motion detection)

Device started moving (according motion sensitivity level 3 )

at 9:00am and 08:00pm (UTC) an inventory message is sent regardless the ignition state
Configuration SMS:
0011{6digitsIMEI},,,,
300 , 1000 ,220000700000, 1 0000009,00000 2 000 2222222 00000000 22 000000,,,,,,
0, 540 , 1200 ,0,24,,,, 3 , 60 ,,,, 30 ,6
Connection to the server – configuration
In case you use your own server, the SW integration of Telic’s proprietary protocol is mandatory
(otherwise received data will be meaningless).
The following configuration command sets some IP parameters in the device, allowing the same
to connect the proper server.
00b1{6 digits-IMEI}IP Address,IP Port,APN,USERNAME,PASSWORD,
(SMS command)
Or:
IPCONFIG=IP Address,IP Port,APN,USERNAME,PASSWORD,
(serial command)
APN, USERNAME and PASSWORD must be adapted according to the SIM card (Provider).
In case there is no Username (or Password), you have to digit: “”.
When you send an SMS, you must wait for an SMS reply by the device (Ack) confirming IP address,
port, and APN credentials ( you can disregard the other parameters ).
Example:
IP Address: 78.137.103.86 (this is in particular the IP address of telic.kentaur.cc)
IP Port: 1561
APN: internet.m2m.de Username: m2m Password: sim
{IMEI} = last 6 or 15 digits of IMEI – 353322088
958773
Final SMS:
00 b1 958773 78.137.103.86,1561,internet.m2m.de,m2m,sim,
Reply by the device: