Teli CSDS60CM3, Инструкция по эксплуатации

Страница: 16 / 28

D4168926B 6
7
． ． ． ．
FUNCTION
Each following functions are possible to control by PC from though the camera control connector.
(1) Output pixels
It is possible to change two kinds of output pixels. (Factory setting
：
1280(H)×720(V))
・
1280(H)× 1024(V) (Aspect ratio 5
：
4)
・
1280(H)× 720(V) (Aspect ratio 16
：
9)
(2) Setup-level setting
It is possible to set the setup-level. A setting range is -16LSB
～
+16LSB. (Factory setting
：
8LSB)
(3) Gain setting
There are 2 modes of MANU(manual) mode and AUTO mode. (Factory setting
：
AUTO)
A setting range is 0
～
+24dB.
AUTO mode is always regulate gain depending on the brightness of an object. It is possible to setting max
gain of this time.
(4) White balance
There are 3 kinds of modes of MWB(Manual White Balance), OPWB(One Push White Balance),
AWB(Auto White Balance). It is possible to choose it to a subject, a use. (Factory setting
：
OPWB)
・
MWB(Manual White Balance)
R-gain and B-gain can be set independently.
Setting range
：
0dB
～
12dB
・
OPWB(One Push White Balance)
It is regulated by one push so that RGB of the center of image area become equal.
・
AWB(Auto White Balance)
It is always reproduced kept images of the balance and pursuit the change of the source of light
automatically.
(5) Aperture
It is possible to set aperture correction revision of the output picture.
A setting range is 8 phases (0~7) each High frequency and Low frequency. (Factory setting
：
3)
・
Phase up : Picture’s edge is emphasized.
(6) Gamma correction
It is possible to set gamma correction of the output picture with 17 phases(0~16). (Factory setting
：
5)
・
Phase up : The shading of the shade become clear.