Televic TCS5500, Руководство по установке

Страница: 119 / 125

Appendix E
Installation manual to TCS5500 Appendix E
● 111
On this set, there is:

a slide switch ON/OFF: when testing, you turn the switch to
ON.

a SUBD 9 connector (an adapter to the RJ-45 connecter is
supplied with the tester).
Televic cable tester receiver CTR5500
Fig.: CTR5500
On this set, there are:

4 leds for the ‘signal lines’ + corresponding pin number and
color wire

4 leds for the ‘power lines’ + corresponding pin number and
color wire

a turn switch: sensitivity tuning

a push button: start test

a SUBD 9 connector
Note that the TMS5500 and TIS5500 network uses RJ45
connectors in stead of the SUBD 9 connectors which were used in
previous versions of the Televic conference system. Therefore a
connector converter is necessary to test the cabling in the network.
The numbers on the CTR correspond to the pin numbers on the
SUBD 9 connector. The table below describes the translation
between the SUBD 9 and RJ45 connector.
SUBD 9 RJ45
10p 10c
(contact pin
position)
RJ45
10p 10c
(8 contacts
loaded)
Function
/ / 1 /
White/orange 8 2 1 +48V
Orange 9 3 2 +48v
Blue 4 5 4 UPL+
White/Blue 5 6 5 UPL-
Green 1 7 6 DWNL+
White/Green 2 4 3 DWNL-
Brown 8 9 8 GND
White/Brown 7 8 7 GND
/ / 10 /