Televes FSM 500, Руководство пользователя

Страница: 9 / 104

Note on charging the battery:
=> Whenever possible, it is advisable to recharge the batteries completely. In other words,
when the recharging process begins, do not interrupt it, until the batteries are 100% full.
=> If you are not going to use the equipment for a while, the battery level should not be very
low. The batteries will discharge slowly while the equipment is not in use, therefore it is
advisable to carry out a recharging process every 2 or 3 months if the batteries are stored
in a room temperature of 25ºC. The higher the room temperature, the more frequent the
recharging process.
=> The batteries should be recharged when they are inside the meter and using the DC adapter
that is provided with the equipment or by providing a current within the specified range (12
- 14,8 V). This is the only way to ensure that the batteries have a long life.
=> For the batteries to work properly, it is necessary to charge and discharge the batteries
completely various times.
1.3.- START-UP
The equipment has a battery already inside, so to switch the equipment on, press the ON
button (10). You do not need to connect the equipment to the mains. Once this button has
been pressed, all of the LEDs will light up for a few seconds. During this time, the Televés logo
will appear onscreen as will the equipment’s software version.
Once a few seconds have passed, all the LEDs will switch off, except the ON LED.
If the equipment is connected to the mains, the Ext. Sup. (green) LED will also stay on. If the
batteries are less than 40% full, these will begin to recharge and the Battery LED (green) will
light up as can be seen in the previous section.
Multimetter FSM 500 Ref. 5903
9