Teletek electronics TP2000, Инструкция по установке и эксплуатации

Страница: 9 / 36

TP2000 Transmitter
-
Installation and Operation Manual 9
Write to Transmitter Button
Stores the settings in the transmitter. In order to do this the transmitter has to be
connected to the PC and supplied with power.
exit Button
Before pressing this button make sure you have stored the modifications you have made
by selecting the Write to Transmitter command.
Note: If you are using Programming Kit for TP2000 V.6.X Transmitter you will find and
a Help button in the bar menu.
Help Button
Opens a file with instructions about using the program .
The inventory number field is situated in the upper left corner of the main screen.
Inventory numbers are set up at the time of manufacture and is uploaded from the unit
on selecting the read from Transmitter command.
2.2.2 Radio Tab
Below the
Bar menu
are to be found four tabs that control the basic settings of the unit:
radio , inputs , Test mode and COm .
The first tab you can select from the main screen is radio - the general view of the
radio tab is shown on Figure 3.
There are three field groups in this tab:
•
Frequency ;
• Identification ;
• radioControl, as well as a button that calls up an additional settings advanced
screen.
• Deviation .
2.2.2.1 Frequency Group
The Frequency field group, see Figure 5, contains two fields with the transmitter’s
transmission frequencies that have been set at the time of manufacture. No corrections
are allowed in these fields.
In this group of the radio screen you can check what are the frequency settings of your
transmitter.
Figure 5.
The Frequency Field.
Note that in the Fx1 and Fx2 fields will be
set transmission frequencies at the time
of manufacture.