TELES VoIPBox BRI, Справочное руководство

Страница: 57 / 280

4 Configuration files
VoIPBox BRI Version 18.0.002 Page 57
All necessary information for setup of the PPPoE connection
is defined in the [pppoe<x>] section. That means username,
password and authentication protocol are set here. The Eth-
ernet interface is emac1 and the gateway can also be defined.
The parameter PppoeIf defines the physical Ethernet inter-
face used (always emac1). The settings are entered as follows:
[pppoe<x>]
PppoeIf=emac1
User=<user>
Pwd=<pwd>
AuthProto=<pap|chap>
Route=<ip_gw> (optional)
Bear in mind that configuration of the firewall, the NAT mod-
ule and prioritization of the VoIP packets must be considered
when routing voice and data through the DSL line.
Table 4.5 Settings in the
[pppoe<x>]
Section of the
ip.cfg
[pppoe<x> ]
PppoeIf=<interface>
Enter the Ethernet interface used for the DSL connection (usually emac1).
User=<username>
Enter the username used for DSL access.
Pwd=<password>
Enter the password used for DSL access.
AuthProto=<protocol>
Enter chap or pap for the protocol used for authentication.
Route=<ip-addr> (optional)
Enter the target IP address range, e.g. 0.0.0.0 (default route). All packets that are not
defined for the local network will be sent through this interface. In this case, the pa-
rameter DefaultGW in the [System] section ( Chapter 4.1.1
→
) must remain empty.
Only network ranges can be routed. The syntax in this case is Route=<target range> -
netmask <ip mask>. If several different network ranges are used, you must enter the
Route parameter for each range.