Telereef Controller - User Manual V.140313
!
minutes until the reading is stabled.
9. Push pH4 button and confirm the setting.
10.Raise the pH probe with RO water or Distilled water.
11. Dry the probe and put inside pH10 calibration solution, wait 2 minutes until the
reading is stabled.
12.Push pH10 button and confirm the setting.
!
• Adjust 10V dimmer output
!
Telereef TR1D provides two dimming channels for LED dimmable driver (eg. Mean Well
ELN-60-48D), one for White LEDs and one for Blue LEDs. Two dimming channels output
0 - 10V to controls the brightness of each channel. These dimming channels have been
factory adjusted 10V at 100% output before shipping; however, the output voltage may
need to be readjusted if different power adapter is used.
(Skip this step if you don’t have a LED 0-10V Dimmable Driver at this moment)
!
1. Go to Home page, push 100% button on White Channel, after the page refreshed
then push 100% button on Blue channel as well.
!
2. Plugin Dimmer 10V Trim Cable to Dimmer Port “B”
3. Set multimeter to Voltage, connect Red line to multimeter’s positive “+” port, connect
Black line to multimeter’s negative “-” port.
4. Insert small screwdriver into 10V Trimer B hole, turn the screw inside until the voltage
reading is 10V.
!
!
5. Plugin Dimmer 10V Trim Cable to Dimmer Port “W”
6. Set multimeter to Voltage, connect Red line to multimeter’s positive “+” port, connect
Black line to multimeter’s negative “-” port.
7. Insert small screwdriver into 10V Trimer W hole, turn the screw inside until the
voltage reading is 10V
!
Congratulation ! Your Telereef Controller is ready to use.
!
7
