Telemark TT-10, Инструкция по эксплуатации

Страница: 23 / 38

WARNING: Care should be used to set the switch to a range
appropriate for the available line power. Note if the switch is
set at 230 but powered by 115, no damage results, but full
power cannot be achieved. Conversely, if the switch is set at
115 but powered by 230, damage will likely result.
SWEEP OUTPUT CONNECTION - J3
Connection of the Sweep generator to an EB gun coils is accomplished by
bringing the Longitudinal and Lateral coil leads out of the vacuum tank by way of
a feed-through. In the vacuum tank, take care to dress these leads away from the
EB gun filament assembly and filament conductors. (This is further discussed in
EB gun manuals.)
Outside the tank, still keep the coil leads away from the high-voltage
feed-throughs. These leads are then connected to pins 1, 2, & 3 of the Sweep’s
J3. The Sweep Output connector provided is a round metal 3-pin male Philmore.
Pin 1 is the Lateral output, pin 3 the Longitudinal, and pin 2 is the common
ground-return; BOTH coils return to pin 2—-the common is shared. The cable
must be capable of passing a minimum of two amperes. Note the common return
is not grounded inside the Sweep, but must be grounded at the EB gun tank.
WARNING: Leaving the common ungrounded at the tank could
damage the Sweep.
TT-10/15 POWER SUPPLY CONNECTION - J1
The interface between the Controller and the supply is the special 15-P Male
D-Sub to 25-P female D-Sub. The Controller option allows Electron-Beam Power
Supply operation via the Sweeper’s special Controller/Joystick Module.
INSTALLATION
3-11
Telemark TT-10/15 Power Supply
Figure 3-H
Sweep
Module
Connections