4
Assembly and connection
20 / 56
DoorLine Slim DECT
4.6.6
DoorLine registration
Note:
The DoorLine permits registration to a PBX system only during the first
15 minutes after application of the power supply. Readiness for registration can
be activated again for 15 minutes at any time by briefly interrupting the
voltage supply.
The DECT-PIN of the DoorLine cannot be changed and is permanently set to
0000. If a different DECT PIN is configured on your PBX system, it must be
changed prior to registration to 0000.
Important:
The DECT-PIN is not the PIN code for configuration of the DoorLine
Slim DECT.
Further information on changing the DECT-PIN is available in the Operating In-
structions of your PBX system.
The DoorLine remains for up to 2 minutes in registration mode. If you
have to cover a long distance to reach your PBX system, first change
the DoorLine to registration mode. The time required can vary accord-
ing to the PBX system.
1. Apply the voltage supply.
ð
The DoorLine starts up. If the surrounding area is dark, the DoorLine light-
ing switches on.
2. Switch your PBX system to registration mode.
3. Actuate both bell pushbuttons for 5 seconds.
ð
Press both buttons at the same time because otherwise normal ringing of
the bell will be detected.
ð
When the button is pressed, a double acknowledgement tone sounds
immediately.
ð
After 5 seconds, a single acknowledgement tone sounds. The buttons
can now be released. The DoorLine registers at the base which is now
ready for registration.
4. After successful registration, a double acknowledgement tone sounds.
ð
Your PBX system assigns a new internal call number for the DoorLine. The
DoorLine can now be reached and can call under this call number.
ð
If registration is unsuccessful, a negative acknowledgement tone sounds
(eight short beeps in succession). Registration could not be carried out
successfully and has to be restarted.
