TeleEye RV432, Инструкция по эксплуатации

Страница: 15 / 60

MDR Manual
14
II-11 MDR Visual Orientation
Front Panel Layout (Recording Module):
1.
LED Indicator and Status Display:
[10M/100M]
Network connection speed: LED ON for 100M bps, LED off for 10M bps.
[LINK/ACT]
Network connection activity light: LED blinking indicates data transfer.
[HDD]
Hard disk drive activity: LED ON indicates system is reading/writing to hard disk.
[REC]
Video recording status: LED ON indicates recording is on for at least one channel.
[ALM]
Alarm status: LED ON indicates unit is currently responding to an alarm condition. Alarm
can be caused by an external sensor trigger, hard disk failure and video loss
[POWER]
Input power status: LED ON confirms that unit is powered.
[ERR]
Error status with USB connection: LED blinks while USB connection problem occur.
[ACC]
USB connection status: LED blinking indicates data transfer using USB port.
[CF]
CF card status: LED ON indicates that CF card is inserted and the data is accessible.
L Notice: when the [ALM] on, caused by video loss or trigger “High Speed Limit” sensor, require login as
administrator to disable the alarm LED and buzzer from control panel;
2. IR Receiver Lens:
Please ensure that the MDR is installed where the handheld IR controller can be pointed
directly to the IR receiver lens. Point your handheld controller at the spot on the recording
module allowing the unit in responding to commands from the controller.
3. CF Card Slot:
To upgrade the MDR software and transfer files without the use of a PC, use an industry
standard Compact Flash card and the handheld controller. For uploading instructions refer to
section labeled as “System Upgrade Firmware Procedure”
4. USB Port:
The USB 2.0 transfer port allow to transfer data file from mobile unit to PC, also MDR can act
as host device to copy advertising clips from USB thumb drive.
(1) LED Indicator (2) IR Receiver (3) CF Card Slot (4) USB Port