Teledyne Foxy R1, Инструкция по эксплуатации

Страница: 21 / 102

Foxy
®
R1 and Foxy
®
R2 Fraction Collectors
Section 1 Introduction
1-9
Table 1-5 Pump Connector Pins
Connector Pin Type Description
1 Input Count: pump volume signal
a
2 Output Pump pause: stops pump between tubes
and at end of run
b
3 Output Valve output: control signal for optional
high flow diverter valve
4 Common Circuit common
5 Output +24 VDC Output: power for optional high
flow diverter valve
6 Not used
K Shield Earth ground
a. Input is +3.3 to 5 VDC or contact closure, active low, 30 ms minimum, 5 VDC maximum.
b. Output is open collector, active low, 15 VDC/100 mA maximum
Table 1-6 Detector Connector Pins
Connector Pin Type Description
1 Common Analog common for use with pin 8
2 Input Ext peak
a
3 Not used
4 Output Event: pulse delivered at tube change
b
5 Input Inject: starts an inject cycle1
a
6 Input Tube Advance1
a
7 Common Circuit common
8 Input Analog detector signal: used for peak
detection
c
K Shield Earth ground
a. Input is +3.3 to 5 VDC or contact closure, active low, 30 ms minimum, 5 VDC maximum.
b.
300 millisecond output is open collector, active low, 15 VDC/100 mA maximum.
c. Analog input is 0 to 1.0 V nominal, –1.2 to +1.2 V usable, –5.0 to +5.0 V maximum.