Teledyne CP030, Руководство оператора

Страница: 7 / 32

Operator’s Manual
1
Safety Instructions
Follow these instructions to keep the probe operating in a correct and safe condition.
Observe generally accepted safety procedures in addition to the precautions specified
here. The overall safety of any system incorporating this accessory is the responsibility
of the assembler of the system.
Symbols
These symbols appear on the probe body or in documentation to alert you to important
safety considerations.
CAUTION , possibility of electric shock.
CAUTION of damage to probe or instrument, or WARNING of hazard to health.
Attend to the accompanying information to protect against personal injury or
damage. Do not proceed until conditions are fully understood and met.
Do not apply around or remove from UNINSULATED HAZARDOUS LIVE
conductors which may render electric shock, electric burn, or arc flash.
Equipment protected by double insulation or reinforced insulation.
CAUTION , hot surface.
Precautions
Comply with the following safety precautions to avoid personal injury or
damage to your equipment:
Use only as specified . The probe is intended to be used only with compatible Teledyne
LeCroy instruments. Using the probe and/or the equipment it is connected to in a
manner other than specified may impair the protection mechanisms.
Do not use the probe for measurements on Mains circuits. The probe should only be
applied around or removed from insulated limited energy circuit conductors that are
not directly connected to the mains.