This document does not contain any export-controlled information.
Installation
15
Quasar CP-6302 Range Installation Manual - Ver. 5 - December 24, 2021
Warning:
1. This product contains a battery that is soldered to the PCB. There is a risk of explosion if the
battery is replaced by an incorrect type.
Do not replace the battery
. The battery should be
disposed of in accordance with manufacturer’s instructions, local codes, or WEEE standards.
Replacement of the battery by the customer will void the product warranty.
Avertissement:
1. Ce produit contient une batterie soudée à la PCB. Il y a un risque d'explosion si la batterie est
remplacée par un type incorrect.
Ne pas remplacer la batterie
.
La batterie doit être éliminée
conformément aux instructions du fabricant, aux codes locaux, ou aux normes WEEE. Le
remplacement de la batterie par le client annulera la garantie du produit.
4.2.2
Connecting the Unit to the Network
A Cat 5 or Cat 6 Ethernet cable is recommended for network connection. To ensure transmission quality,
cable length should not exceed 100 meters (328 feet). Connect one end of the Ethernet cable to the
RJ45 connector of the system cable. Plug the other end of the cable into the network switch or PC. Check
the status of the link and the activity LEDs. If the LEDs are unlit, check the LAN connection.
A steady green link LED indicates a good network connection.
The yellow activity LED flashes to indicate network activity.
Note:
An Ethernet crossover cable might be needed when connecting the camera directly to the PC.
4.2.3
Connecting Leads to a Spring Clamp Terminal Block
The unit is delivered with 2-pin, 3-pin, and 14-pin terminal block connectors. The connectors enable you
to connect wires for either the relay output or alarm input and then connect them to the unit.
To connect a wire to the spring clamp terminal block
1. Strip the insulation form the end of each wire that is to be connected to the terminal block.
Approximately 1 cm (2.54”) of wire should be exposed.
2. With a small screwdriver, press in and hold the orange spring clamp button next to the
female outlet where the wire will be inserted.
3. Insert the stripped end of the wire into the female outlet.
4. Release the orange spring clamp button.
