This document does not contain any export-controlled information.
Installation
13
Quasar CP-6302 Range Installation Manual - Ver. 5 - December 24, 2021
4.2.1
Connecting Power to the Camera
This product is intended to be used with a Listed Power Adapter with LPS. The camera is powered by
PoE+ (IEEE802.3at, class 4, CP-6302-31-P and CP-6302-30-R only), UPOE (CP-6302-31-I, CP-6302-
31-P, and CP-6302-30-R), 24VAC, or 30VDC power source (not included in the package).
·
If using an external power supply, connect the power leads or three-pin power terminal block to
the power supply.
·
If using PoE++ or UPOE, make sure that a Power Sourcing Equipment (PSE) device is used in
the network.
·
If connecting to a UPoE-capable network switch, use Teledyne FLIR-recommended unit
otherwise check with support.
Make sure the camera’s power cable is properly connected. All electrical work must be performed in
accordance with local regulatory requirements.
CP-6302-31-I
Caution:
1.
If the camera is connected to a PoE network, note that the PoE supply’s rated output is 55VDC,
0.91A.
2.
If the camera is installed for outdoor use, the PoE supply must be installed with proper
weatherproofing.
3.
As a Listed Power Unit, the PoE should be marked as “LPS” or “Limited Power Source”.
4.
This product shall be installed by a qualified service person. Installation shall conform to all
local codes.
5.
If the camera is connected to a 30VDC power supply, the power rating is 4.17A
6.
If the camera is connected to a 24VAC, 50-60Hz power supply, the power rating is 2.09A
Attention:
1.
Si la caméra est connectée à un réseau PoE, notez que la puissance nominale de
l'alimentation PoE est 55VDC, 0.91A.
2.
Si la caméra est installée pour une utilisation extérieure, l'alimentation PoE doit être installé
avec l'étanchéisation appropriée.
3.
Comme une unité d'alimentation «Listed», le PoE doit être marqué comme «LPS» ou «Limited
Power Source".
4.
Ce produit doit être installé par un technicien qualifié. L'installation doit se conformer à tous les
codes locaux.
5.
Si la caméra est connecté à une unité d'alimentation 30V cc, la puissance nominale est 4.17A.
6.
Si la caméra est connecté à une unité d'alimentation 24V ca,50-60Hz la puissance nominale
est 2.09A.
For CP-6302-31-P:
Caution:
1.
If the camera is connected to a PoE network, note that the PoE supply's rated output is 55VDC,
0.39A.
2.
If the camera is installed for outdoor use, the PoE supply must be installed with proper
weatherproofing.
3.
As a Listed Power Unit, the PoE should be marked as “LPS” or “Limited Power Source”.
4.
This product shall be installed by a qualified service person. Installation shall conform to all
local codes.
5.
If the camera is connected to a 30VDC power supply, the power rating is 1.62A.
