Teledyne Lecroy Summit Z58, Быстрый старт

Страница: 6 / 8

7. Plug in the output cable of the Power Adapter to the power connector on the Summit Z5 Controller Board (see figure below):
8. Install the PCIe Protocol Analysis Software following the steps below (See section "6" ).
9. Power ON the
Summit
Z58 system.
10. Use PCIe Protocol Analysis Software to configure it and start the exerciser/analyzer (See section "8" ).
11. You can setup and connect the Summit Z58 to your host machine though either a USB or Ethernet connection. (See section "7" ).
12. After the Summit Z58 is setup and connected, the next step is to connect your DUT to the system and start recording traffic (See
section "8" ).
13. Power ON the host DUT.
Warning: Do not disconnect the 12" cable while the Summit Z58 system is powered ON.
Note: If the Summit Z58 will be installed in a PXP500 or Gen5 capable platform, follow the installation steps in the Summit Z5 User Manual .
Push the power plug into
the controller’s power
connector until you hear a
"click" noise.
Controller’s
Power Connector
Power Plug (about to be
attached to Controller)
Note: To disconnect the power cable from the Controller Board, the outer sleeve of the end of the connector must be pulled back to
free the locking mechanism. With the sleeve pulled back, the connector can be disconnected from the Controller Board.
Make sure airflow is not blocked to the intake for the Summit Z58. This may happen when
installing a large DUT card on the slot next to the Summit Z58 Main board.