Assembly Instructions
If the
Summit Z58
is to be used to emulate a root complex it will usually be installed in the Teledyne LeCroy PXP500
™
or other Gen5
capable Test Platforms. In this case, please refer to the Teledyne LeCroy PXP500 or other platform specific documentation for detailed
installation instructions.
If the Summit Z58 is going to be installed into a motherboard or backplane, follow the steps below:
1.
Make sure host system if powered Off.
2.
Plug Z58 main board in the PCIe Slot near the Z5 Controller.
3.
Secure Z58 main board bracket to host chassis with screw.
4.
Attach 12" cable to the Z58 main board. The connectors are keyed so only one end can be connected.
5.
Attach the TX SSC CLK cable to the connector on the front of the Main Board.
6.
Gently tighten the cable screws with your fingers make sure the connector is properly attached.
Do not use tools or Overtighten
.
7.
Attach the other end of the 12" cable to the Z58 Controller board making sure the connector is properly attached and the screws
gently tightened.
Do not use tools or Overtighten
.
Align Cable with Main Board
Attach Cable to Exerciser
Card and Gently Tighten Screws
Align Cable with Controller Board
Attach Cable to Controller
Board and Gently Tighten Screws
5
