•
PCI Express 5.0 M.2 M-Key Interposer CrossSync
PHY Capable Carrier board
•
Connector cable assembly 18 inches for
connection to host slot
•
DC Power Adapter (+12V @ 3 Amps)
•
Depending on configuration: SMA to BNC 3ft
Cable
•
Extension bracket kit (metal brackets with clip)
supporting M.2 devices of 60, 80 and 110mm
devices (depending on purchased configuration
two more bracket sizes 30 and 42mm included)
•
Thumbscrew and standoff
•
User Manual and Quick Start Guide (this
document)
2
Interposer Cable Assembly Installation
If required, install a different extension bracket to the small PCB at the end of the 18" interposer cable. The extension
brackets are provided to allow the user to attach and secure the Teledyne LeCroy M.2 interposer cable on the host system
which usually supports different M.2 card form factors. Follow below instructions to install the extension brackets that will fit
your application.
Cable Assembly for Screw Attachment with 42mm PCB Configuration
The cable comes already with the Type 2260 bracket extension installed. To install a different bracket follow below
procedure. The Teledyne LeCroy M.2 Interposer Extension Bracket Kit contains the items listed below. The items are
shown in the figure below.
•
Type 22110 Extension bracket
•
Type 2280 Extension bracket
•
Type 2260 Extension bracket.
•
Screws to attach the Extension bracket to the interposer Cable Assembly
M2 Interposer Extension Bracket Kit
3
Components
The Teledyne LeCroy 5.0 M.2 M-Key Interposer CrossSync PHY Capable kit has the following components:
