Optical Modulation Analyzer
16
Connect Standard RF Cables
Follow these instructions to connect the standard
RF cables (IQSCABLES-SBW) to the acquisition
module’s 2.92mm interfaces. The supplied RF
cables are labeled
'XI'
,
'XQ'
,
'YI'
, and
'YQ'
.
CAUTION
Do not bend or deform the cables, as this will damage them. Connect cables as labeled.
The cables are calibrated to perform within specification only when connected as labeled.
1.
Using the
‘XI’
RF cable, attach the 1.85mm/2.4mm connector
to the
X-Pol I
port on the
coherent receiver.
Then, attach the 2.92mm connector
to the
CH1
port of the acquisition module.
2.
Repeat this using the following cables and inputs:
•
Attach the
‘XQ’
RF cable from the
X-Pol Q
port on the coherent receiver to the
CH2
port of the
LabMaster acquisition module.
•
Attach the
‘YI’
RF cable from the
Y-Pol I
port on the coherent receiver to the
CH3
port of the
LabMaster acquisition module.
•
Attach the
‘YQ’
RF cable from the
Y-Pol Q
port on the coherent receiver to the
CH4
port of the
LabMaster acquisition module.
Your system should look like this:
Содержание IQS25
