6
(b)
(a)
(d)
(c)
(f)
(e)
1 - Setting relay function (impulsive, on/off, timer)
1.1 - IMPULSIVE function
Press once
SET
button and hold it down until the
IMP
led turns ON. Release
the button and wait until the led turns off, to confirm the memorization of
the data.
Before starting select the output
CH1
or
CH2
, using the jumper (see picture at page 5).
The following configuration will be applied
only
to the selected output.
Warning:
the receiver automatically saves the settings 5 seconds after the button release.
1.2 - ON/OFF function
Press twice
SET
button and hold it down the second time, until the
ON-OFF
led turns ON. Release the button and wait until the led turns off, to confirm
the memorization of the data.
Note:
once reached the maximum or minimum limit, the led will turn off and the value will no longer be increased or decreased.
1.3 - TIMER function
1- Setting the seconds (1 to 59)
(a) Press 3 times
SET
button and hold it down the last time, until the
SEC
led
turns ON. (b) Adjust the seconds increasing with
MEM
button or decreasing
with
DEL
button. Each press corresponds to a unit increased or decreased.
Wait for exit the procedure saving the data or proceed with the next setting.
2- Setting the minutes (1 to 59)
(c) Press the
SET
button another time (within five seconds) and hold it down
until the
MIN
led turns ON. (d) Adjust the minutes increasing with
MEM
button
or decreasing with
DEL
button. Each press corresponds to a unit increased
or decreased. Wait for exit the procedure saving the data or proceed with
the next setting.
3- Setting the hours (1 to 8)
(e) Press the
SET
button another time (within five seconds) and hold it down
until the
HOU
led turns ON. (f) Adjust the hours increasing with
MEM
button
or decreasing with
DEL
button. Each press corresponds to a unit increased
or decreased. Wait for exit the procedure saving the data.
