TeleAdapt TA-7500L MediaHUB HD, Руководство по установке

Страница: 26 / 34

TA-7650 and TA-7750 Installation Manual
Last Revision: 9/30/11 11:23 AM
26
Troubleshooting
MediaHub HD Troubleshooting
If the MediaHub HD does not seem to be working properly, lights are not illuminating and TV
is not auto-swtiching, try these troubleshooting procedures:
A
Fully remove AC power to the TV. Power cycle the MediaHub HD. Then re-apply
power to the TV and use the remote control to turn the TV on. Wait 30 seconds
before activating any input source into the MediaHub HD.
B
Ensure the HDMI cable is placed in the correct HDMI slot.
C
Ensure the proper DIP Switch Mode Settings are correct on the MediaHub HD
according to the brand of your TV.
D
Ensure the proper firmware versions and video driver versions are those that are
required for your STB/TV supported application. Use the On-Screen Display to
verify.
How to Access the On-Screen Display
The On-Screen Display (OSD) is a support feature that reports the snapshot
specification list of the MediaHub HD’s current technical settings and firmware
versions. Below are instructions to access the OSD.
1
|
When MediaHub HD is connected to a TV, select the HDMI AUX source, then
press the Audio/PC LED button so the orange light appears.
2 | Press and hold both the Audio/PC and USB/Bluetooth buttons for 15
seconds, until the Audio/Video and Audio/PC LED lights start blinking.
3
|
On-Screen Display will show on the TV screen.
4
|
To exit OSD Mode, press and hold both the Audio/PC and
USB/Bluetooth LED buttons for 15 seconds, until the Audio/Video and
Audio/PC LED lights stop blinking.
E
Ensure the proper TV configuration was set between the MediaHub HD
and TV/STB (baud rate, control settings, etc.)
Step 2: Then press and hold both the
Audio/PC and USB/Bluetooth LED
buttons for 15 seconds until lights blink.
Step 1: Access the On-Screen Display
by first pressing the Audio/PC LED
button.